Materials Technology. Services

Materials Technology. Services

Mechanical Test

Led_crculo_naranja2 Determination of the mechanical properties at constant temperature (range of temperatures: from -70ºC up to 250ºC): tensile tests, three-point bending tests, compression and compression in flat deformation tests.

Led_crculo_naranja2 Specific test of Mechanism of the fracture: toughness determination (KIc and GIc), determination of J0.2 and JIc, construction of resistance curves J-R, determination essential work of fracture.

Led_crculo_naranja2 Determination of the impact strength: pendular impact (Charpy, Izod, Impact-traction), falling dart impact (-40 ºC up to 150 ºC)

Led_crculo_naranja2 Determination of the fracture toughness by instrumented impact



Thermal and Reological Test

Led_crculo_naranja2 Analysis through Diferential Scaning Calorimetry (DSC): determinació of the thermal characteristics (glass transition temperature, melting enthalpy...), studies of thermal ageing, studies of of crosslinking processes. influence of the additives.

Led_crculo_naranja2 Detemination of Tg through Dynamic Mechanical Thermal Analysis (DMTA)

Led_crculo_naranja2 Determination of the heat deflection temperature (HDT)

Led_crculo_naranja2 Determination of Vicat softening temperature

Led_crculo_naranja2 Melt flow index gravimetric (MFI) and volumetric (MVR)

Led_crculo_naranja2 Determination of the intrinsic viscosity

Contact: This e-mail address is being protected from spambots. You need JavaScript enabled to view it



Mixing and additivation

Reactive extrusion, mixing of polymers, compatibilization of polymers, incorporation of fillers, fibres and additives, preparation of concentrates (masterbatch)


Sheet extrusion-calendering, film extrusion-blowing, cast film, extrusion parameters optimization, relationship between conditions of extrusion and properties, determination of the anisotropy in extruded products


Mould checking, production of short series and pre-series, simulation, optimization of moulds processing window, shrinkage analysis of injected parts, mucellTM microfoaming

Contact: This e-mail address is being protected from spambots. You need JavaScript enabled to view it